Page 1 of 1
S1 inside photo
Posted: Fri May 10, 2024 2:39 pm
by MiyaCulpa
I am adding a photo for those who are curious about the inside of the computer. While I was opening it, I renewed the thermal paste with high quality Mastergel maker.
Re: S1 inside photo
Posted: Fri May 10, 2024 4:11 pm
by dragonpoo
Nice job, MiyaCulpa. I admit, I was curious what the other side of my S1 looked like, but since there's really no reason to take it apart (unless I have thermal paste), I think I'll be keeping it intact.
Did you notice any performance or temperature differences between the stock paste and what you put in?
Re: S1 inside photo
Posted: Fri May 10, 2024 5:06 pm
by MiyaCulpa
dragonpoo wrote: ↑Fri May 10, 2024 4:11 pm
Nice job, MiyaCulpa. I admit, I was curious what the other side of my S1 looked like, but since there's really no reason to take it apart (unless I have thermal paste), I think I'll be keeping it intact.
Did you notice any performance or temperature differences between the stock paste and what you put in?
It drops 3-4 degrees
The screen on it does not show the temperature exactly correctly, I measured it with hwmonitor
Re: S1 inside photo
Posted: Fri May 10, 2024 5:12 pm
by MiyaCulpa
I also installed two M.2 coolers that I cut from 2mm aluminum and applied thermal paste between them.Because normal M.2 coolers are thick, the magnetic cover does not close.
The temperature dropped by 5-6 degrees
Re: S1 inside photo
Posted: Fri May 10, 2024 6:28 pm
by dragonpoo
Those are noticeable differences in temperature, nice job!
Re: S1 inside photo
Posted: Sun May 12, 2024 12:42 pm
by Paolo57120
Je l'ai fait aussi, j'ai gagné 6 degré ou plus et le couvercle ferme bien (Refroidisseur M.2, 70X22X3mm)
