How to clear CMOS on S1 model?
How to clear CMOS on S1 model?
How to clear CMOS on Acemagic S1 N100 model in case of wrong settings in UEFI Setup? PC shows black screen and fan works. Jumper or button not found. I'm install DDR4 2666 instead 3600.
-
Gabe
- Senior Moderator
- Posts: 2031
- Joined: Fri Apr 17, 2020 1:19 am
- Has thanked: 42 times
- Been thanked: 116 times
Re: How to clear CMOS on S1 model?
If you're not able to boot into the BIOS to reset everything to default there, I would contact barry777, a tech for the company, at barry@minipcunion.com.
If you see instructions on this forum for other models that include shorting out the CMOS battery connector poles on the motherboard, I wouldn't do so on this, as there's not yet been any indication that doing so would be the procedure for this model.
If you see instructions on this forum for other models that include shorting out the CMOS battery connector poles on the motherboard, I wouldn't do so on this, as there's not yet been any indication that doing so would be the procedure for this model.
W8 Pro • GK1 • AK3 • AM02 • T6 Pro • AMR5 • GK3 Pro • AD03 • AM06 Pro • T8 Pro • S1 • T8 Plus • CK10 • AK2 Pro
I have no connection to ACEMAGIC other than being a customer and long time forum member
I have no connection to ACEMAGIC other than being a customer and long time forum member
Re: How to clear CMOS on S1 model?
First, power off the device.
Access the BIOS interface and restore BIOS settings.
Perform a black screen operation.
1. Simultaneously press the power button and immediately press and hold F7 for about 10 seconds. The PC will enter the BIOS interface;
2. Press F3 (restore BIOS settings), then press F4 (save BIOS settings), and the PC will automatically restart.
It is recommended not to change BIOS settings.
3. Reconnect the HDMI cable or replace it with another HDMI cable.
Access the BIOS interface and restore BIOS settings.
Perform a black screen operation.
1. Simultaneously press the power button and immediately press and hold F7 for about 10 seconds. The PC will enter the BIOS interface;
2. Press F3 (restore BIOS settings), then press F4 (save BIOS settings), and the PC will automatically restart.
It is recommended not to change BIOS settings.
3. Reconnect the HDMI cable or replace it with another HDMI cable.