Page 1 of 1
AM06 Pro - how to reset BIOS to factory without monitor connected
Posted: Mon Jul 17, 2023 2:11 pm
by gsky2
I accidentally set the iGPU Configuration to "iGPU Disabled" and saved the changes. Now I have no signal from the HDMI out so I cannot get back into the BIOS to re-enable it. Is there a way to reset the BIOS by using a jumper or something similar?
Re: AM06 Pro - how to reset BIOS to factory without monitor connected
Posted: Mon Jul 17, 2023 3:18 pm
by gsky2
I figured it out. There are 3 red pins labeled "HW_CLR_CMOS1" located on the corner of the board near the NVME. In the normal state, the red jumper is installed on pins 1+2. To clear the reset the BIOS to factory settings:
1. Unplug the power
2, Put the jumper on pins 2+3 for a few seconds
3. Put it back to pins 1+2
Hope that helps someone. Pity these things aren't documented in the motherboard manual.
Re: AM06 Pro - how to reset BIOS to factory without monitor connected
Posted: Tue Jul 18, 2023 3:23 am
by barry777
Try not to make some changes in BIOS settings.
Maybe try:
1. Connect a wired keyboard;
2. Press and hold the [Delete] key when the computer is not turned on (do not let go)
3. Press the power button, wait for about 6~8 seconds and release the [Delete] button
4. Press【F3】(restore default settings), and then press【F4】to save
Then see if it shows up.