Best Minipc Forum

Hello,


i was in the bios today and saw that the ddr4 ram is set to 2400mhz. When I ordered it from Amazon, I saw ddr4 with 2933 MHz.

Can I just change that in the bios? I'm a bit afraid that the MiniPC won't start up anymore. With my previous PC I was able to remove the bios battery for a few seconds, put it back in and then it booted again, I don't know how it is with the MiniPC.


I'm using Gentoo Linux and compiling software in a 12GB RamDISK so it's faster than the SSD. It makes a big difference here whether the RAM is set to DDR4-2400 (19,200 MB/s) or DDR4-2933 (23,000 MB/s).

Changing the DDR speed is not recommended, it may cause no boot issues; I checked with product development to see if this option can be changed.

Hello Barry,
I would like to inquire whether you have already received a response from “Product Development” in the last 5 months?
Today I saw again on Amazon that the ak1pro is advertised with DDR4-2933.

Best regards

Hello. Please provide your Amazon order number and send it to me via private message or email: barry@minipcunion.com. We will contact you as soon as possible after verification.

barry,

In case it helps, the Amazon page showing this is here...

www.amazon.com/ACEMAGICIAN-Computers-Wi ... B0C3QMZCK8

It's the fourth picture down on the left, where you can choose which picture you want to look at.

Refers to the maximum support of 2933 MHz;
Using 3200 MHz DDR4, after changing the frequency in the BIOS, it can reach 2933 Mhz under the Windows system interface.