AK2 (6 + 120) PRO can’t connect to Ethernet
Posted: Wed May 13, 2020 8:38 am
1. Plug in the internet cable under the system and check whether the wired network icon in the lower right corner has a yellow exclamation mark.
2. If there is an exclamation mark, you need to go to the Ethernet adapter to check whether the assigned IP address is normal (see the figure below)
3. If it is not correct, you need to click to automatically assign an IP address (see the following figure), and then restart once, OK;
2. If there is an exclamation mark, you need to go to the Ethernet adapter to check whether the assigned IP address is normal (see the figure below)
- 1.jpg (161.16 KiB) Viewed 2325 times
- 2.jpg (69.13 KiB) Viewed 2325 times