Best Minipc Forum

Dante4 wrote: ↑Tue Oct 18, 2022 11:56 pm Well, that's more about experience, NTFS is only Microsoft filesystem, even Linux not yet fully have support over it. And here is just UEFI, almost all motherboard may be flashed only from fat/fat16/fat32 flash drive.

Dante4 wrote: ↑Tue Oct 18, 2022 9:39 pm

Gabe wrote: ↑Tue Oct 18, 2022 9:31 pm a blue screen that said something like "EFI Update complete", indicating that the flash had completed. So, I then waited. Ten minutes, twenty minutes --- an hour. I knew that doing anything wrong with a BIOS flash can brick the unit, so I didn't dare do anything. I was assuming that the entire process was automatic, and the end result would be automatically booting back to Windows. Finally, after about an hour and twenty minutes, I typed 'exit' and hit Enter, darn near having a heart attack while doing so, worrying that every single thing I did was going to kill the unit.

Yeah, that's was a bit unexpected, but you should have noticed the errors "fs5 not found", "fs6 not found". And inside script there is a simple "foreach" for fs[1-6], fs is basically where BIOS is.

Gabe wrote: ↑Tue Oct 18, 2022 9:31 pm It rebooted, then nothing. The screen went dead. I waited a few minutes, and nothing. The unit was on, as the lights on it were on, but it was showing nothing on the screen.

That's strange. I got instantly back to BIOS then I loaded to the OS.

But after I rebooted I too met black screen until I clicked hibernate again. But I always have the problem with my type-c screen, the AMR5 refuses to send video to it after it's goes to power safe mode until i replug it, so at least I wasn't panicking. That much i mean

JosephDMcCarthy wrote: ↑Sat Jul 06, 2024 10:23 pm Can you help me know what the script is or what command line to write to install "fs0/1/2/3/4/5/6", I tried updating the normal bios as shown in the previous examples, but I get the same Same errors at the end as in the video, the "fs0, etc.." were not found. I have little knowledge of computers.

Excuse me, I am a Spanish speaker and I am using Google Translator in case it is written wrong.

Gabe wrote: ↑Sun Jul 07, 2024 12:40 am

JosephDMcCarthy wrote: ↑Sat Jul 06, 2024 10:23 pm Can you help me know what the script is or what command line to write to install "fs0/1/2/3/4/5/6", I tried updating the normal bios as shown in the previous examples, but I get the same Same errors at the end as in the video, the "fs0, etc.." were not found. I have little knowledge of computers.

Excuse me, I am a Spanish speaker and I am using Google Translator in case it is written wrong.

I would contact barry777, a tech for the company, at barry@minipcunion.com and ask for help.

Unless it's a fully automated process, like it often is with many big name PC and motherboard manufacturers, I'm pretty much lost when it comes the ins and outs of flashing a BIOS. Anything more complex that simple Windows commands are out of my league. That I didn't brick my AMR5 when I flashed the BIOS was pure luck.