2. If there is an exclamation mark, you need to go to the Ethernet adapter to check whether the assigned IP address is normal (see the figure below)
- 1.jpg (161.16 KiB) Viewed 2319 times
- 2.jpg (69.13 KiB) Viewed 2319 times
AK2 (6 + 120) PRO can’t connect to Ethernet
-
admin
- Site Admin
- Posts: 2045
- Joined: Mon Mar 16, 2020 9:11 am
- Has thanked: 79 times
- Been thanked: 46 times
AK2 (6 + 120) PRO can’t connect to Ethernet
1. Plug in the internet cable under the system and check whether the wired network icon in the lower right corner has a yellow exclamation mark.
2. If there is an exclamation mark, you need to go to the Ethernet adapter to check whether the assigned IP address is normal (see the figure below) 3. If it is not correct, you need to click to automatically assign an IP address (see the following figure), and then restart once, OK;
2. If there is an exclamation mark, you need to go to the Ethernet adapter to check whether the assigned IP address is normal (see the figure below) 3. If it is not correct, you need to click to automatically assign an IP address (see the following figure), and then restart once, OK;
Thanks for joining the forum fans, we will become friends here. Any suggestions about the forum I am open to hearing.
-
Shieda Kayn
- Posts: 10
- Joined: Thu May 21, 2020 1:37 am