GK3V Install Files

Post by **Bradders** » Sat Jan 27, 2024 3:09 pm

Hi there, I need to reinstall the complete system as needed to replace the 256K memory card. I see comments on the forum to there being files on the Forum....can somebody kindly point me in the right direction to find these please.

many thanks

Phil

Post by **Gabe** » Sat Jan 27, 2024 6:45 pm

Bradders,

Unfortunately, the system currently listed on the site for the GK3 is Windows 10 Pro 2004, which isn't even supported by Microsoft anymore. I'll contact barry, a tech for the company, to see if there is a more up to date version available, such as 22H2, and then post when I find out. He may also post it here himself.

Post by **barry777** » Tue Jan 30, 2024 7:58 am

GK3V Windows 11 Pro system:Download link

Installation system tutorial video

Post by **Bradders** » Wed Jan 31, 2024 9:55 pm

Many thanks Gabe/Barry, for your swift response, I will down load and install.

I note from other comments there is discussion about needing to update the BIOS or such for windows 11 - Do I need anything further other than install the file downloaded please?

Thanks again.

Phil.

Post by **Gabe** » Wed Jan 31, 2024 10:19 pm

Some GK3 models support Windows 11 from the get go, while some that don't do have BIOS updates available.

Your best bet is to enter the BIOS on startup (press and hold or repeatedly press the Del key) and see what version it has. Apparently they have a BIOS update for the three versions listed in this post.

Post by **Bradders** » Thu Feb 01, 2024 4:38 pm

Once again Many thanks Gabe for your swift response, much appreciated:-)

Post by **Gabe** » Thu Feb 01, 2024 6:47 pm

Bradders wrote: ↑Thu Feb 01, 2024 4:38 pm Once again Many thanks Gabe for your swift response, much appreciated:-)

You're quite welcome.

Post by **Bradders** » Thu Feb 01, 2024 6:59 pm

Hi Gabe, sorry to bother you again, but I am in unknown territory here;-). I down loaded the Rar file for version V25. It loaded the bios up date successfully as per the word doc, but then stopped as shown in the attached photo! The next process seems not to have run! What do I need to do please?

Post by **Gabe** » Thu Feb 01, 2024 7:10 pm

Bradders,

I would contact barry, a tech for the company, directly at barry@minipcunion.com. Hopefully he'll be able to help get it straightened out.

Post by **Bradders** » Thu Feb 01, 2024 8:30 pm

Barry, are you able to help please?

Thanks

Phil.

Best Minipc Forum

Thanks for visiting and welcome to register and communicate with mini PC enthusiasts around the world.